Log in

Login to your account

Username *
Password *
Remember Me

Becht Engineering Blog

In this section of the site contributing authors submit interesting articles relating to the various services, industries and research & development efforts of Becht Engineering.

CFD Modeling of a Mixing Tee – Part 1: Model Validation

cfd-mixing-T-cover
by Dave Dewees, Zumao Chen and L. Magnus Gustafsson This 2-part blog deals with CFD modeling of a mixing tee that is often found in industry. Traditional simulation is validated against experiment, as well as a new commercially available method that offers the possibility of substantial solution time reduction.  In fact, the new method is shown to give accurate results in a much shorter computer time than the traditional analysis, allowing much more rapid turnaround of difficult problems such as the turbulent mixing behavior of industrial mixing tees. When there is a large temperature difference between two fluid streams, large temperature fluctuations can occur, which can lead to thermal fatigue of the piping system, even at “steady-state” bulk flow conditions. Advanced CFD modeling is capable of predicting these fluid temperature fluctuations at the mix point, as well as characterizing the corresponding temperature variations in the pipe wall itself. Specifically, large eddy simulation...
Continue reading
2
  462 Hits
  0 Comments
462 Hits
0 Comments

CFD Modeling of a Mixing Tee – Part 2: Predictions of Temperature Fluctuations

cfd-mixing-T-cover
by Dave Dewees, Zumao Chen and L. Magnus Gustafsson Miss Part 1? Click Here This is the second part of a 2-part blog.  In Part 1, the stress-blended eddy simulation (SBES) and large eddy simulation (LES) approaches for simulating turbulence have been validated against test data obtained from a mixing tee. In this part, the SBES approach is used to predict temperature fluctuations in a mixing tee where light gas oil mixes with a recycled gas.  Depending on the characteristics of the streams being mixed (momentum and temperature), protection from rapid temperature variations occurring even at steady-state bulk flow conditions is a necessity. While a CFD model can predict these temperature variations with good fidelity as shown in Part 1 of this blog, once a problem is found, the same CFD model can also be used to design solutions that protect the piping at the mix point.  Here thermal sleeve length...
Continue reading
1
  508 Hits
  0 Comments
508 Hits
0 Comments